Installing new trim on “Standard Companion”

Standard Companion integral spout sink
AmStd metal spout Companion sink

Re-trimming (replacing the handles and escutcheons) on American Standard China Shelfback sinks from the 1930’s through the fifties (like the above examples) used to be almost impossible due to a lack of available parts. Here at Bathroom Machineries, we’ve discovered a simple way to make your sink look new again. It will require a bit of homework on your part first, as Standard used two different stems in identical looking sinks.

Note! Only do the following if you want to replace the trim on your sink. If the trim is good and it’s simply leaking out of the spout, refer back to the stems page.

Remove the existing stems from your sink after shutting off the water. Note the length of the large fine thread on your bonnet nut. You’ll have two options, either the thread will be 5/16” (less common) long or it will be 1/2” (far more common) long. Once you know the length, you can order our re-trim kits.

American Standard Bonnet

If your bonnet nut is 5/16” long, (left side of above photo) then you will want to order the 86-061HM kit. If the bonnet is 1/2” long, (right side of above photo and FAR more common) you will want to order the 86-081HM kit.

Both kits are supplied with the following;

  • Two stems
  • Two escutcheons
  • Two escutcheon nipples
  • One pair handles with buttons

Photo at right shows the 86-081HM kit, this is the more common version.

Note; the escutcheons will be of a similar design to the originals, but they will not be exactly the same. They are slightly wider and taller than the originals. See below.

 

 

Original (no longer made) version is on left, replacement that comes in kit is on right.

Note, many sinks of this style were supplied with lever handles. If using this kit, the sink is converted to cross handles. A lever handle version is not available.

Chrome only, no other finishes available.

Trip levers are not made anymore, but often we can replate the existing lever. Call or e-mail for details.

Original style drains aren’t made anymore either, but they can be replaced with our 79-P85C pop-up assembly. You will need to save the drain linkage that connected the lever to the drain from the original assembly, as this is a brand -specific, unobtainable part.

Yes! We found it! This is a reproduction of the stopper for the above Standard Lavatory drain that was in use from the 1930’s to the mid 1960’s. Chrome only, it measures 5 1/4” long and the top is 1 3/8”. Fix your drain today!

Standard Lavatory Pop-Up Drain Stopper

This is the drain top for Standard Brand Lavatory pop-up drains made from 1932 up through the mid 1960’s.  Chrome only.  Make your sink look new today!

Standard drain top for 1930-1960 pop-up drains

This is the washer set used between the porcelain and the metal nut on almost all Standard brand lavatory pop-up assemblies made between the mid 1930’s up to the mid 1960’s. ID of basin washer is just under 1 7/16”.

Mack Basin Washer Set