Straight Rods, D-Rods, U-Rods, L-Rods, Neo-Angle Rods

77-157 Neo Angle Corner Shower Rod
Made of 1" O.D. brass tubing (two pieces connected by a knurled insert) 30" x 24" x 30". Furnished with two No. 77-300 rectangular flanges.

Yes, the 156 and the 157 look very similar

77-340 Ceiling Support Rod for 1" Rod
1/4" diameter rod with ceiling flange, screws and 1" I.D. loop.
Fits all 1” o.d. 77-series and 79-series rods. (does not fit 77-150 ring.)    Adjustable ceiling supports will not fit these rods

Blowout prices on Brass shower Rods! Click here!!!!

J-Hook Ceiling Supports
J-hooks are installed by drilling a 1/2” hole on the underside of the curtain rod, just off center. When used with our
 clear plastic or heavy S-type curtain pins, J-hooks allow the curtain to slide freely past the ceiling support. An example of our obstruction-free ring using these J-hook may be seen on our shower rings page.

 J-hooks may be added to just about any 7/8” or 1” O.D. Shower rod or ring. Replace the OEM ceiling support with a
 J-hook and buy a set of our special curtain pins to add the convenience of obstruction-free curtain movement to your existing shower rod or ring!
Installation instructions for the J-hooks, click HERE.

Be sure to check out our
NEW! Ultimate Shower Rods
 By Bathroom Machineries

Not Finding the Shower Rod you want?
We build Custom Shower Rods! Our shop specializes in re-engineering exisitng rods or building entirely new rods from scratch. Call or Email for details.

Glossary of Plumbing Terms:
OD Outside Diameter of tube.
ID Inside D iameter of tube.
FIP Female Iron Pipe, has threads on inside of fitting.
MIP Male Iron Pipe, has threads on outside of pipe or fitting.
IPS  Iron Pipe Size. Standard brass and galvanized pipe size.
3/8” Iron Pipe has approximately a 1/2” ID and an 11/16” OD.
1/2” Iron Pipe has approximately a 5/8” ID and a 7/8” OD.
3/4” Iron Pipe has approximately a 13/16” ID and a 1-1/16” OD.
(Note: “Pipe” is sized by it’s minimum ID at the fitting, “Tubing” by the pipe’s exact O.D.)
3/8 Brass Tubing and 3/8” copper Tubing are 3/8” OD.
1/2” copper water pipe has a 5/8” OD.
3/4” copper water pipe has a 7/8” OD. (note: OD for pipe is always the same, no matter what grade or “weight” of pipe is used.)
Copper Tubing is sized by it’s actual OD. (Ex: 1/2” tubing measures 1/2” OD. The ID of the tubing will vary with the grade and weight of tubing used.)